Electric motor radio controlled card E-PRG-3

Protronik E-PRG-3 programming card for brushless controllers (except BF-32 series)

The Protronik E-PRG-3 programming card is the essential tool to precisely configure your brushless controllers from the brand, except for the BF-32 series.

Designed to be simple and intuitive, it allows you to adjust many key settings: battery type selection, cut-off voltage, brake activation, rotation direction of Protronik motors, timing adjustment, and much more.

Direct power supply without external source

The Protronik E-PRG-3 card is powered directly by the connected controller via the propulsion battery, so no additional power supply is required.

This system works with both BEC-equipped controllers (PM10A, PM20A, PM30A, PM40A) and those without BEC (PM60A, PM70A, PM80A OPTO and PM120A OPTO).

Available settings

• Brake: Off / Medium / On (default: Off)

• Battery type: NiXX / LiPo 2 to 8S

• Low voltage cut-off: 47 / 55 / 63 / 71 % (NiXX) or 2.7 / 2.8 / 2.9 / 3.0 / 3.1 V (LiPo)

• Motor cut-off: Off / Power reduction / Hard cut-off (default: power reduction)

• Rotation direction: Normal / Reverse (default: Normal)

• Start-up: Soft / Medium / Normal (default: Medium)

• Timing: Auto / Low / Medium / High (default: Auto)

• Switching frequency: 8 / 16 kHz (default: 8 kHz)

The detailed manual is supplied with the programming card, but here is a quick summary to guide you.

How to use the E-PRG-3 card

1. Connect the servo lead of your ESC to the programming connector on the card, respecting the wire color code (see manual). For PM60A, PM70A, and PM80A OPTO controllers, also connect the shorter second servo lead.

2. Connect the battery to the controller, making sure to respect the polarity.

3. After a few seconds, a beep confirms that communication between the Protronik card and the controller is established. You can then:

   • Check programming status: red LEDs display the current settings.

   • Modify settings: LEDs indicate the selected values for each parameter.

How to change parameters

• Select the parameter to change with the NEXT / MENU button (the LED blinks).

• Change the value using NEXT / VALUE.

• Save and go to the next parameter by pressing NEXT / MENU again.

• Repeat the process until all settings are configured.

• Finally, disconnect the battery.